How to use the pipe clamps

Maybe a lot of people don't know, what is pipe clamp, more do not know how to use the pipe clamps. Pipe clamp is mounted to guide rail, rail welding in basis, or with screws, then push the guide screw nut in orbit, and 90 degrees, the second half of the pipe clamp body embedded nut, put that need to be fixed on the tube, put up half of the tube clamp body and cover plate, screw fixation. Moreover, the application range of the pipe clamp is relatively extensive, generally there are three types: light pipe clamp used in 6 kinds of size series of ordinary mechanical pressure pipe, the pipe diameter 6-57 mm; Double pipe clamp used in five series of mechanical pressure pipe size, pipe diameter 6-42 mm; Heavy series pipe clamp used in eight kinds of series of high mechanical pressure pipe size, pipe diameter 8-273 - mm. So, for how to use the pipe clamp, but also need for the installation of pipe clamp on the order from. 

   Pipe clamp material properties are also embodied in many aspects: density, bending strength, impact toughness, compression strength, elastic modulus, tensile strength, heat resistance, good color. These not only can guarantee the quality of pipe clamp, but also can ensure the practicability of pipe clamp. However, for the installation of the pipe clamp order also have exquisite: before assembly on the welded plate assembly, to better determine the direction of the clip, suggested in a fixed place ready first, after welding on welding, embedded in the lower part of the pipe clamp body, put the pipe should be fixed. Put the other half pipe clamp body and cover plate, with a screw. Avoid direct welding has installed pipe clamp plate. Folded assembly, based on the guide rail welding in, or with screws, first to pack up and down half of the pipe clamp body, put that need to be fixed on the tube put up half of the pipe clamp body, with the screw, through the locking plate prevent it from turning. Then install the second tube clip to the above method. Bend pipe assembly, assembly bent pipe, shall be directly on the bend in the front and the rear insein pipe clamp is fixed. Suggested that this should be a fixed position of supporting points. So, through this introduction, you can very good understand that how to use the pipe clamps.