How to put tires chains on

 Tyre protection chain is used at home and abroad advanced production technology, using high quality alloy steel material, the precision casting, fully automatic flash butt welding of high strength, reasonable structure, the use of special welding process of welding a tire protection equipment. For manufacturers,how to put tires chains on , is a big problem. Maintain chain good abrasion resistance, fatigue resistance is strong, according to the conditions of use life of 3000-8000 hours. Tear open outfit is convenient, save time and effort, the products are complete in specifications, can match with imported loader, tyre protection chain, using high-tech wear-resisting material, the new structure is compact, stable performance, mainly is suitable for the mining operation of the loader, the tire wear fast, short service life, the tire is expensive, the cost is high, will this product tightly wrapped in loader tires, can effectively protect the loader tires, not by the sharp rocks cut prick, prolong the service life of the tyre, use a tyre protection chain, can save the cost of more than ten tyres, can improve the work efficiency and safety of loader is an essential for mining operation. According to the performance and characteristics of this kind of tyre protection chain, by looking for information on how to put tires chains on  for you below tire chains. 

   However, the installation tyre protection chain is need tools to cooperate. Required tools: a hammer, pliers, wire (about 1 meter) 1. Put the loader in plain area, will the gas released about a third of the tire. 2. Expand the chain, paving in the need to install directly in front of the tire (share the lateral). Section 3 will accessories (opening section and the diamond opening), with about 1 meter wire on one end of the chain. 4. Start the loader, pay attention to the tire positive positive alignment with the chain. 5. On the pattern of the tire with wire, with a crowbar straighten chain, vehicle slowly move back, until all wrapped the tyre protection chain (front, rear back forward). 6. After the good on both ends of the chain, with a connection section connection at both ends. 7. Good tire lateral tightening chain, tightening and debugging. 8. Check the tyre protection chain lock ring, make its joint outwards, so as not to tire wear. The eight steps for you to talk about how to put tires chains on , again with the help of some tools to cooperate, so huge and difficult engineering easily.